Instructions on how to use the Urinator ^TM

The Urinator is very easy to use. It is very important that you practice at home.  READ THE INSTRUCTION MANUAL and feel comfortable before using it in a testing situation.

For the Original Urinator, please download the PDF below and watch the help video.

For the Urinator BT, the next generation Bluetooth version with phone app, you also need to download and read the Urinator BT PDF and see the video.

1. Fill the bag - Use the provided syringe and fill the bag with approximately 75 to 85 ml of warm water or warm urine. Ideally, you need to start with a fluid temperature at 98.6 or above. When doing that, we guarantee 4 hrs of correct temperature maintenance when using DURACELL batteries.
   
   
2. Remove excess air - Remove as much air from the bag as possible and screw cap back on the end of the tube*.
   
   
3. Attach batteries - Attach your two 9-volt DURACELL batteries and fold fabric shut, making sure to secure the ends.
   
   
4. Wait for the correct temperature - Once your temperature indicator on the bag is reading 98 to 100 you are ready to give your sample.
   
   

What could be easier?

Tips for using the Urinator

1. *Do not over-tighten cap"  (it will get stuck for good).
   
   
2. Only use duracell batteries.
   
   
3. When disconnecting batteries, do not pull wires, remove at batteries at caps.
   
   
4. When done with use, after disconnecting batteries, rinse fluid bag with water 2-3 times, leave cap off for approx. 48 hrs, allowing inside of bag to dry.